A blanket design for using sample books

When I saw this interior decor fabric sample lot, I was attracted by the shining look . I thought it would be nice to make satined glass appliqués with them, but they are too thick to make appliqués.
Most pieces are 5"X12", so I thought about those simple blocks with large pieces. When grouping them in colors, finally, I drew two slightly different patterns with the same block. The first one looks like windmills, the 2nd looks like stars to me.

Comments

Patchwork backpack made of old Jeans

This summer is not a craft summer for me, I spend a lot of time in my front and back yards. Only after sunset, mosquitoes occupy the yards, I go back to my sewing room and do some craft. I'm quite pleased with this scrappy look backpack, it was made of an old jean and some 11/2"squares. inside look applique the square stripe onto the jeans make a flip cover

Fabric tulip Tutorial

Here comes the tutorial for the Fabric Tulips. Hope you'll like it Supplies: fabric: pedel-shaped : 3 leave- shaped 2 wire 20gauge 14" flower tape 13" fiberfill Tools: Glue gun Pliers Note: I drew white lines to show where to sew. Procedures: Step !: make the stem A. Stretch the tape gently, after stretch, it becomes a little sticky, B. Wrap the tape around the wire, starting 1/2" from one end, don't worry about the unwrapped part, it'll be hidden inside the bud. C. Use pliers to make a loop at the unwrap end Step 2: make the bud A. take 2 pieces of the pedal-shaped fabric, right face together, sew one side only, leave 1/4" seam allowance B. Sew the third piece and the piece made in step A together, right face together, it should look like this C. Turn inside out Step 3: Make the leave A. Sew the 2 peice of leave-shaped fabric together, leave the bottom open B.Turn inside out C. Sew along the edge Step 4:Assemle the tulip A. Fold the raw edge of the bu...

Low Cost Patchwork Board

When I mark on fabric, sometimes fabric moves and stretches, which annoys me. Last week, I found a product named Patchwork Board(produced by Clover, a Japanese Company), a kind of marking board has a built-in sandpaper surface to hold fabric in place so you can mark accurate lines, and the opposite side is an ironing board surface. The price listed on the official website is US$29.95. Today, I tried to find this patchwork board in 3 local stores, they don't have it. So I decided to make one myself. I went to Canadian Tire and bought a piece of Ultra fine sandpaper (the finest sandpaper in store) at $0.27 + tax. :) I glued it on hard paper board, and glued a layer of batting on the wrong side, then cover the batting side with a piece of fabric( larger than the hard paper board), folded the fabric to the sandpaper side and glued the edge to cover the edge of the sandpaper. Voila!! In about half an hour, I made a marking-ironing board for less than $1.00. If I know it, I wouldn...

Yimi Handwork

Search This Blog