Fabric Covered Boxes

More boxes :). I used to put my fabric scraps in a plastic bag, which I always did't like much. Last week, I reorganized my fabric stash and found a few pieces I bought a year ago just when I started doing patchwork, those pieces were too thin to be used in patchwork but would be perfect to cover boxes. I also made two redwork pieces to decor the boxes. The pot one was a leftover of a wall hanging, I cut it off and used fusible webbing to attach it, the bear one was stitched on using blanket stitch.

My scraps have a nice house ever since.

Comments

Patchwork backpack made of old Jeans

This summer is not a craft summer for me, I spend a lot of time in my front and back yards. Only after sunset, mosquitoes occupy the yards, I go back to my sewing room and do some craft. I'm quite pleased with this scrappy look backpack, it was made of an old jean and some 11/2"squares. inside look applique the square stripe onto the jeans make a flip cover

Fabric tulip Tutorial

Here comes the tutorial for the Fabric Tulips. Hope you'll like it Supplies: fabric: pedel-shaped : 3 leave- shaped 2 wire 20gauge 14" flower tape 13" fiberfill Tools: Glue gun Pliers Note: I drew white lines to show where to sew. Procedures: Step !: make the stem A. Stretch the tape gently, after stretch, it becomes a little sticky, B. Wrap the tape around the wire, starting 1/2" from one end, don't worry about the unwrapped part, it'll be hidden inside the bud. C. Use pliers to make a loop at the unwrap end Step 2: make the bud A. take 2 pieces of the pedal-shaped fabric, right face together, sew one side only, leave 1/4" seam allowance B. Sew the third piece and the piece made in step A together, right face together, it should look like this C. Turn inside out Step 3: Make the leave A. Sew the 2 peice of leave-shaped fabric together, leave the bottom open B.Turn inside out C. Sew along the edge Step 4:Assemle the tulip A. Fold the raw edge of the bu...

Low Cost Patchwork Board

When I mark on fabric, sometimes fabric moves and stretches, which annoys me. Last week, I found a product named Patchwork Board(produced by Clover, a Japanese Company), a kind of marking board has a built-in sandpaper surface to hold fabric in place so you can mark accurate lines, and the opposite side is an ironing board surface. The price listed on the official website is US$29.95. Today, I tried to find this patchwork board in 3 local stores, they don't have it. So I decided to make one myself. I went to Canadian Tire and bought a piece of Ultra fine sandpaper (the finest sandpaper in store) at $0.27 + tax. :) I glued it on hard paper board, and glued a layer of batting on the wrong side, then cover the batting side with a piece of fabric( larger than the hard paper board), folded the fabric to the sandpaper side and glued the edge to cover the edge of the sandpaper. Voila!! In about half an hour, I made a marking-ironing board for less than $1.00. If I know it, I wouldn...

Yimi Handwork

Search This Blog